Skip to content

Drain Jetting Wangi Wangi

Drain jetting in Wangi Wangi drives a pressurised water head along a blocked pipe, washing grease, silt and root mass off the wall instead of poking a hole through the clog. The quote is fixed before the pump starts, and the hose feeds in through an opening that already exists, so nothing gets dug.

The team behind the hose. Wangi Wangi Plumbing Co is the plumber in Wangi Wangi for this work, and the jetter rides with the rest of the blocked drains gear on every drain job.

Licensed plumbers and gas fitters · NSW Lic. 359278C

Last updated September 2026

Plumber working at the hose reels on the back of the ute

When does a drain need the jetter?

Not every blockage needs high-pressure water, but these signs point that way before we arrive:

  • The same drain has blocked again after an earlier clear
  • A kitchen, laundry and bathroom all slowing at once, so the shared line has narrowed
  • Grease or silt is the likely cause, such as a kitchen line that runs slow but never fully stops
  • A camera inspection has shown buildup along the pipe wall rather than one solid obstruction

A cutting eel bores a hole in the blockage but leaves the coating on the pipe wall behind. The jet takes that coating off the full bore, so the line starts again from clean.

Plumber working a drain-clearing machine

How We Jet a Drain

The job runs in a set sequence, and you see the result at the end.

  1. 01

    Access first

    We find the nearest trap or inspection opening and feed the hose in from there, so the yard stays intact.

  2. 02

    Pressure matched to the pipe

    Old earthenware gets a different setting to PVC, and the camera footage tells us which we are dealing with before the pump starts.

  3. 03

    The scour

    The jet head pushes forward while high-pressure water strips the walls clean and washes the debris back toward us.

  4. 04

    The proof

    A camera pass after the jet shows the line clean and reveals anything that caused the trouble, like a cracked joint or a root entry point.

Thick root masses need the cutting head from tree root removal first. Pipe that is split or broken after jetting is a job for pipe relining.

What Sets the Price of Jetting?

What sits behind that figure:

  • Length of line Ten metres of kitchen waste is a smaller job than the whole sewer to the street, or a stormwater line running down a sloping block.
  • What comes out Grease washes fast; a line packed with silt and root mass takes longer and more water.
  • Access A surface trap near the driveway is quicker than an opening buried behind a garden on a low foreshore block.
  • The camera check Filming before and after the jet costs more than a clear alone, but it shows the cause instead of guessing.

Why the low ground blocks hardest

The slope does the damage

Wangi Wangi's streets run downhill to the lake, so grit and sand washing off the higher ground end up in the lines on the foreshore blocks at the bottom. Runs that have lost their fall hold water and silt, and that sludge is exactly what a jet strips out.

Roots rough up the wall

Leafy streets and the bushland reserve at the point keep roots pressing on the old clay lines beneath fibro and weatherboard houses. Fine root hair inside a joint catches grease and silt, and a slow line becomes a blocked one.

Rain and groundwater pile on

The rain gauge for this area averages 1,120 millimetres a year, and the lowest ground by the water carries a shallow water table, so groundwater seeps into any crack and drags the drainage down further. A jetted line on that ground flows properly again, and the footage tells us whether a crack needs more than a clean.
Plumber pulling fittings from the ute drawers

What Customers Say

We talked through the options of our blocked kitchen sink drain (not just an s bend problem) and came to the perfect long term solution at a reasonable price.
Debbie

When we're not the right call: our jetter stops at your junction. A choke in the street sewer beyond it is for Hunter Water to clear, while a backed-up sewer line on your own land is ours.

Questions people ask about jetting

Is jetting safe for the old earthenware drains in Wangi Wangi?

Yes, provided the jet is set for the pipe it is in. Water is gentler on old earthenware and clay than a mechanical eel, because it does not scratch or gouge the wall. We set the pressure to suit whatever the camera shows, so a fragile line gets a careful clean instead of a blast.

Will jetting stop tree roots coming back into my line?

It strips out the fine roots and flushes them away, but a joint that let roots in once will let them in again. Filming the line afterwards shows which joint is open, and sealing it with a liner is the longer-term answer.

Do you need to dig up the yard to jet a drain?

No. The hose goes in through a trap or inspection opening that already exists, and the water does the travelling. On the sloping blocks near the shore, that also means no trenches through gardens that are hard to restore.

How is jetting different from a plunger or a chemical cleaner?

A plunger shifts a clog near the trap, and chemicals sit in the water without reaching the blockage. Jetting pushes a head along the full line and cleans the whole wall as it goes, so the entire pipe is flushed, not just the spot that backed up.

Need a plumber? Call or send the form

Call (02) 4093 0558 or send the form below. Available 24/7, you see a fixed figure ahead of any work, and every job carries our 365-day warranty on all work.

Call (02) 4093 0558

Request a callback

Leave a name and number and a plumber will ring you back.

We use your details only to call you back about this job. See our privacy policy.

Call (02) 4093 0558 Get a quote